TOOLS:

You will need a utility knife, some white chalk, a square or straight edge and a tape measure.

INSTALLATION STEPS:

1. Clean stall thoroughly. If the stall has a soft base, make it as level as possible. This will ensure that the mats will lie flat and make for easy cleaning.

2. Place the required mats in the alleyway outside each stall.

3. Measure the stall and decide on the best fitting pattern for that stall (see below for some common patterns). Bring the mats in one at a time, beginning with the mats that require little or no cutting.

4. Measure the uncovered area, mark the desired mat with chalk and cut to fit using the utility knife and straight edge as a cutting guide.

Cutting Tips:
Score the rubber 2 or 3 times then cut through from one side, pulling the rubber apart as you cut. - it will cut much faster.
Also - you can use a lubricant on the knife blade but be very careful - it will cut much faster.
For best fit - Butt factory edges together and put cut edges to face the stall walls.